|
Below you'll find the most common asked questions about Pullex.
If you have any questions about Pullex or our other products please contact us.
|
|
|
Q.
Can I use my own part-off tool together with Pullex Crocodile?
|
|
|
Yes, Pullex Crocodile is design just for to suite your own square or blade part off tool.
|
|
|
Q.
Can I use both left- and right hand tools?
|
|
|
Yes, the same Pullex Crocodile can be used both for left and right hand tools.
|
|
|
Q.
How do I adjust the pulling plates?
|
|
|
It's easy. You just adjust adjust the Pulling Plates
0.1 mm to 0.2 mm less that the bar diameter.
One way to adjust the pulling plates, when the Pullex Crocodile is mounted in the the
machine is to use the following method:
The adjustment of pulling plates is simplified by turning a diameter of 0.1 mm to
0.2 mm less than the bar diameter. Then, the pulling plates are pushed against the
turned diameter and locked in this position. This method is quick, accurate and
eliminates errors originating from the turret and/or tool holder.
|
|
|
|
|
|
|
Turn a diameter of 0.1 to 0.2 mm less than the bar diameter.
|
|
|
Push the Pulling plates against the turned diameter to be locked in this position.
|
|
|
The clamping force achieved by the Pulling plates entering the
bar is then amplified by the somewhat sagging bar at chuck
unclamp, thus securing safe operation.
|
|
|
|
Q.
Does Pullex works with a spring?
|
|
|
No, Pullex doesn't use any spring which can tear out.
|
|
|
|
Maskinportalen
for machine tool
industry.
- News
- Agent register
- Suppliers
- Links etc.
maskinportalen.se
|
|
|
|
|
home page
